Prosoft-technology MVI56E-DNPNET Manual do Utilizador descarregar pdf (Página 47)

MVI56E-DNPNET ♦ ControlLogix Platform Contents

DNPNET Ethernet Client/Server Communication Module User Manual

ProSoft Technology, Inc. Page 47 of 140

February 13, 2015

LED Label

Color

Status

Indication

GREEN

The module is operating normally.

RED

The module has detected an internal error or is being

initialized. If the LED remains RED for over 10 seconds, the

module is not working. Remove it from the rack and re-insert it

to restart its internal program.

ERR

Red

Not used.

3.2 Clearing a Fault Condition

Typically, if the OK LED on the front of the module turns RED for more than ten seconds, a

hardware problem has been detected in the module or the program has exited.

To clear the condition, follow these steps:

1 Turn off power to the rack.

2 Remove the card from the rack.

3 Verify that all jumpers are set correctly.

4 If the module requires a Compact Flash card, verify that the card is installed correctly.

5 Re-insert the card in the rack and turn the power back on.

6 Verify correct configuration data is being transferred to the module from the ControlLogix

controller.

If the module's OK LED does not turn GREEN, verify that the module is inserted completely

into the rack. If this does not cure the problem, contact ProSoft Technology Technical

Support.

3.3 Troubleshooting

Use the following troubleshooting steps if you encounter problems when the module is

powered up. If these steps do not resolve your problem, please contact ProSoft Technology

Technical Support.

Processor Errors

Problem Description

Steps to take

Processor Fault

Verify that the module is plugged into the slot that has been configured

for the module in the I/O Configuration of RSLogix.

Verify that the slot location in the rack has been configured correctly in

the ladder logic.

Processor I/O LED

flashes

This indicates a problem with backplane communications. A problem

could exist between the processor and any installed I/O module, not just

the MVI56E-DNPNET. Verify that all modules in the rack are correctly

configured in the ladder logic.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 139 140

Comentários a estes Manuais

Sem comentários

Prosoft-technology MVI56E-DNPNET Manual do Utilizador Página 47

Comentários a estes Manuais

Manuais e produtos relacionados com Transmissão Prosoft-technology MVI56E-DNPNET