
Contents MVI56E-DNPNET ♦ ControlLogix Platform
User Manual DNPNET Ethernet Client/Server Communication Module
Page 40 of 140 ProSoft Technology, Inc.
February 13, 2015
DNPNET.CONFIG.DNP_Serv
er_List[x].Spare3_always_0
This value should always be set to zero
DNPNET.CONFIG.DNP_Serv
er_List[x].Application_Layer_R
esponse_Timeout
Time-out period the client will wait for each
response message fragment. If data link
confirms are enabled, make sure the time-out
period is set long enough to permit all data
confirm retries.
DNPNET.CONFIG.DNP_Serv
er_List[x].Server_Mode
Bit 0=Enable
Bit 1=Unsolved
Message Bit
2=Use DM
Bit 3=Auto Time
Sync
This word contains bits that define the server
mode. The server mode defines the
functionality of the server device and can be
combined in any combination.
DNPNET.CONFIG.DNP_Serv
er_List[x].IP_Address
DNPNET.CONFIG.DNP_Serv
er_List[x].Port
DNPNET.CONFIG.DNP_Serv
er_List[x].IP_Type
DNPNET.CONFIG.DNP_Serv
er_List[x].Connection_Retry_In
terval
This is how long in milliseconds the Client will
wait before retrying to connect to a server that
refused the connection. If this field is zero then
the default of 1000 milliseconds will be set.
The max is 10000 milliseconds (10 seconds).
The minimum time is 1 millisecond. If this field
is less than zero this server setup list entry will
be completely ignored by the module.
The default Server List size is five. If there are more than five servers (up to a maximum of
40), you must increase the size of this list.
1 To edit the length of the Server List array, double-click the DNPNETCONFIG UDT
Comentários a estes Manuais