Prosoft-technology AN-X2-SQD Manual do Utilizador descarregar pdf (Página 13)

AN-X2-SQD-MAS Page 7

Ethernet Configuration

Before you can use the AN-X2-SQD-MAS, you must configure its network properties on

Ethernet.

Initial Ethernet Configuration

AN-X can be configured:

• to use a static (unchanging) IP address

• to obtain its IP address from a DHCP server

• to use the fixed link-local address 169.254.42.84

AN-X modules are shipped with the link-local address 169.254.42.84.

Unless you have control of the DHCP server, in most applications you will assign the

AN-X a static IP address. Otherwise the DHCP server may assign a different IP address

each time AN-X powers up, and any software that accesses the AN-X module would

have to be reconfigured.

If you are using multiple AN-X modules, connect and configure one at a time, since

initially they will all be set to the same link-local IP address.

IMPORTANT!

If you are connecting AN-X to an existing Ethernet network, consult the

network administrator to obtain information about how you should

configure AN-X or to obtain a static IP address for AN-X.

You configure the Ethernet properties using the web interface.

Start a web browser and enter the address 169.254.42.84

TIP

The AN-X2 must be on the same subnet as the computer to use the

link-local IP address. It cannot be connected through a router.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Sem comentários

Prosoft-technology AN-X2-SQD Manual do Utilizador Página 13