Prosoft-technology AN-X2-GENI Manual do Utilizador descarregar pdf (Página 22)

Page 16 AN-X2-GENI (AN-X-GENI/B) May 2013

Genius Network Configuration

Before you can scan a Genius I/O network, you must set the AN-X module’s serial bus

address and baud rate and configure the network in the AN-X2-GENI.

Set the baud rate and serial bus address before connecting to the Genius network.

Setting the Bus Address and Baud Rate

From the AN-X web interface, select Automation Network/Genius Baud/Node Settings.

Check the desired baud rate from the four supported baud rates: 38.4Kbps, 76.8 Kbps,

153.6 KBPS standard or 153.6 Kbps extended.

Enter the serial bus address (SBA) for the AN-X, in the range 0 to 31.

Click the Submit Changes button to set the Genius bus properties of the AN-X2-GENI.

Configuring the Genius Network

There are two methods of configuring the Genius I/O that the AN-X2-GENI is to scan:

• autoconfiguration. The AN-X2-GENI reads the network contents by sending

messages to the attached network.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Sem comentários

Prosoft-technology AN-X2-GENI Manual do Utilizador Página 22